Lexmark 4600MFP - Manual (Page 110)

Attendance messages
110
Understanding MFP messages
31.yy Replace defective
print cartridge The MFP detects a defective print
cartridge within 10—20 seconds after
the top cover is closed. Remove the defective print cartridge and install
a nondefective print cartridge for printing to
continue.
During the 10—20 second interval before the
defective print cartridge is detected, the MFP
may continue to print pages; however, the
pages are not reprinted once the new print
cartridge is installed.
32.yy Replace
unsupported print
cartridge The MFP detects an unsupported
print cartridge within 10—20 seconds
after the top cover is closed. Remove the unsupported print cartridge and
install a supported print cartridge for printing to
continue.
During the 10—20 second interval before the
unsupported print cartridge is detected, the
MFP may continue to print pages; however, the
pages are not reprinted once the new print
cartridge is installed.
34 Short paper The length of the print media is too
short to print the formatted data. Touch Continue to clear the message and
continue printing. The MFP does not
automatically reprint the page that prompted the
message.
Make sure the Paper Size setting in the Paper
Menu is correct for the size of print media used.
If MP Feeder Size is set to Universal, make sure
the print media is large enough for the formatted
data.
Touch
Cancel Job to cancel the current job if
needed.
35 Insufficient memory
to support Resource Save
feature The MFP lacks the memory needed
to enable Resource Save. This
message usually indicates too much
memory is allocated for one or more
of the MFP link buffers. Touch Continue to disable Resource Save and
continue printing.
Install additional memory.
37 Insufficient memory
to collate job The MFP cannot collate the job
because the memory is full. Touch Continue to print the pages processed
before the memory became full. Some memory
frees up, so collating begins for the remainder of
the print job.
For example, if a 50-page print job is sent, and
10 copies are requested, and the MFP runs out
of memory at page 30, the MFP would collate
and print 10 copies of pages 1—30. The MFP
would then print and collate pages 31—50 and
print 10 copies of these pages.
37 Insufficient memory,
some Held Jobs were
deleted Held jobs are deleted in order to
process the current job. Touch Continue to clear the message and
continue printing.
To avoid this error in the future for other jobs,
install more memory.
Touch
Cancel Job to cancel the current job if
needed.
38 Memory full The MFP is processing data, but the
memory used to store pages is full. To avoid this error in the future:
Simplify the print job by reducing the amount of
text or graphics on a page and deleting
unnecessary downloaded fonts or macros.
Install additional memory.
Touch
Cancel Job to cancel the current job if
needed.
Touch
Reset Active Bin to change to another
linked bin.
Message Meaning Action