4 scsi backplane, Scsi backplane 4–10 – Sun Microsystems Sun Fire V20z User Manual
Page 62
4-10
Sun Fire V20z Server User Guide • March 2004
4.4.4
SCSI Backplane
The following procedure describes how to replace the SCSI backplane.
1. Turn off the system, including any attached peripherals.
2. While pressing the cover latch release button with your right thumb (A),
slide the
cover towards the rear of the chassis until it contacts the stop (B).
3. Lift the cover up and remove it.
FIGURE 4-9
Removing the Cover
4. Remove all hard disk drive carriers:
a. Squeeze the release latch and swing the arm to the left as far as it will go.
b. Grasp the carrier bezel with both hands and carefully pull the carrier out of the
drive bay.
Note –
Avoid using the arm to remove the carrier.
FIGURE 4-10
SCSI Hard Disk Drive Carrier and Release Latch
A
B