Sun Microsystems Sun Fire V20z User Manual
Page 17
Chapter 1
Introduction to the Sun Fire V20z Server
1-7
lists the operations you can perform from the operator panel:
TABLE 1-3
Operator Panel Menu Options
Menu Menu
Options
Description
Server
Shutdown server
Signals the server operating system to shut down and
power off.
To force the power off in the case where the operating
system hangs, the operator must hold the power button for
four seconds.
Reboot server
Signals the server operating system to shut down and
reboot.
Display Port 80
Displays the last ten Port 80 codes (in hex, 5 per line). Press
any button to clear the display. The display automatically
clears after 30 seconds.
This feature only works in BIOS booting state; to see all the
post codes run the
sp get port80 -m
command.
Panel
Use SP hostname
Displays the service processor’s networking hostname in
the top line instead of its numeric IP address.
Name for LCD
Displays a custom name for the service processor in the
LCD. (For more information, refer to
Sun Fire V20z
Installation Guide
, 817-5246-xx.)
Clear LCD name
Removes the user-specified name for the service processor.
Either the hostname or the IP address displays in the first
line.
Rotate IP/Name
The first line of the LCD alternates every five seconds. For
example, the custom name for the LCD or hostname
displays, then the IP address, then back, and so on every
five seconds.
If you set the Name for LCD, it displays in the top line. If
you do not set the Name for LCD and you do specify the
Use SP hostname, the hostname displays in the top line. If
you specify neither the Name for LCD or the Use SP
hostname options, the numeric IP address displays.
SP
Set SP IP
information
Configures the service processor network using DHCP or a
static IP address. (For more information, refer to
Sun Fire
V20z Installation Guide
, 817-5246-xx.)
Auto Configure Propagates
configuration information to the service
processor. (For more information, refer to
Sun Fire V20z
Installation Server Management Guide,
817-5249-xx
.
).
Update SP
Updates service processor software. (For more information,
refer to
Sun Fire V20z Installation Server Management
Guide,
817-5249-xx.)