Symmetricom XL-GPS User Manual
Xl-gps time & frequency system
Table of contents
Document Outline
- Notices
- Table of Contents
- Preface
- 1: Overview of the XL-GPS Time and Frequency Receiver
- 2: System Specifications
- 3: Installation/Configuration
- Installing the GPS Antenna
- Making Additional Connections
- Connecting the Power Supply
- Configuring the Network Port
- Configuring the Time Display
- Using the Command Line Interface
- Connecting to the Serial Port
- Connecting to the Network Port
- Installing the Expansion Module
- Configuring the Expansion Module
- Verifying Antenna Installation
- Rack Mounting the XL-GPS
- 4: User Interfaces
- 5: Function Reference
- Function Summary
- F1 - Time Zone Offset
- F2 - 12/24 Hour Format
- F3 - Time & Date
- F4 - Serial Port Configuration
- F5 - Time-Quality Setup
- F6 - Keypad Lock
- F8 - Continuous Time Once-per-Second
- F9 - Time On Request
- F11 - Time Output Format
- F13 - Time Error
- F18 - Software Version Request
- F50 - GPS Receiver LLA/XYZ Position
- F51 - GPS Antenna Cable Delay
- F52 - Distribution Cable Delay
- F53 - GPS Operation Mode
- F60 - GPS Receiver Satellite List
- F66 - Daylight Saving Time (DST) Mode
- F69 - Time Mode
- F71 - Oscillator Statistics
- F72 - Fault Status
- F73 - Alarm Control / Status
- F90 - Code Output Configuration
- F100 - Network Port Configuration & XL-GPS Firmware
- F100 EA - Ethernet Address
- F100 IP - IP Address
- F100 SM - Subnet Mask
- F100 G - Gateway
- F100 IC - Network Port Settings
- F100 BASET - 10/100 BASE- T
- F100 L/LOCK/UNLOCK - Remote Lockout
- F100 L - Remote Lockout Status
- F100 ST - Self Test Status
- F100 BH - Burn Host
- F100 BUB - Burn BootLoader
- F100 BU - Burn
- F100 BF - Burn File System
- F100 BUFP - Burn FPGA Firmware
- F100 CONFIG - Configure NTP & SNMP
- F100 J - Factory Mode Jumper
- F100 K I L L - Reboot
- F100 P - Change User Password
- F100 PI - PING
- F100 PN - Change User Name
- F108 - Oscillator Configuration
- F110 - J1 Input (TIET)
- F111 - J2 Output (Rate, PPO)
- F113 - J3 Input (Freq Meas)
- F117 - Factory Configuration
- F119 - GPS Receiver Configuration
- F126 - Options Key Entry
- 6: GPS M12 Receiver (87-8028-2)
- 7: XL-GPS-Generated Messages
- A: Using F100 Configuration
- B: Upgrading System Firmware
- C: SNMP
- D: Network Time Protocol (NTP)
- E: Time Code Formats
- F: World Map of Time Zones:
- G: Part Names
- H: Sales and Customer Assistance
- Index