Symmetricom XL-GPS - Manual (Page 122)

112 997-01530-01, Rev. C-25, Jan 2008
S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S
1
Recovery Action: Verify correct parameter values. If correct, restart the XL-GPS. If this error message
persists, contact Symmetricom Technical Customer Service.
ERROR: Action (get or set) is not specified
You have omitted the “get” or “set” parameter from the F100 NTP Configuration command.
Recovery Action: Re-enter the command, specifying the desired action.
ERROR: Can’t open source file
The file containing the needed data is unavailable.
Recovery Action: Check file location and directory names to verify the path is accurate, then re-enter the
command.
ERROR: Can’t open dest file
The destination file is unavailable.
Recovery Action: Check file location and directory names to verify the path is accurate, then re-enter the
command.
ERROR: Can’t write file
Data from the source file cannot be copied to the destination file.
Recovery Action: Check file location and directory names to verify the path is accurate, then re-enter the
command.
ERROR: Configuration failed.
Your attempt to configure new parameters was unsuccessful.
Recovery Action: Verify parameter values, then re-enter the command.
ERROR: Configuration type is not specified
You did not specify the file type.
Recovery Action: Re-enter the command, specifying SNMP and/or NTP.