Symmetricom XL-GPS - Manual (Page 99)

997-01530-01, Rev. C-25, Jan 2008 89
2
5
1
S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S
XL-GPS responds:
F100 J FACTORY MODE=1
or
F100 J FACTORY MODE=0
F100 K I L L – Reboot
Use function F100 K I L L to reboot the unit. Use F100 K I L L after upgrading the system firmware.
K I L L is a case-sensitive command. When entering this command, use all capital letters and put
spaces between each letter
.
To reboot the unit, enter:
F100 KILL
For example:
F100 K I L L
XL-GPS responds:
OK
RESETING THE UNIT
PLEASE WAIT…
In a network port session, rebooting the XL-GPS terminates the network port session; open a new
network port session when the XL-GPS has finished rebooting. In a serial port session, the XL-GPS
displays text similar to the following example when the XL-GPS has finished rebooting and is ready to
receive additional commands:
>SYSTEM POWER ON SELF TEST RESULTS:
SERIAL LOOPBACK TEST PASSED.
RAM TEST PASSED.
PROG CRC TEST PASSED
NETWORK INTERFACE 192-8001 (c) 1998 - 2003 SYMMETRICOM
ALL RIGHTS RESERVED
FLASH FILE SYSTEM MOUNTED.
SOURCE FILE /config/symmetricom.conf BYTES READ: 1210
FILE SYSTEM REV # 1.80
SCAN_FOR_OPT_CARD BEGINS.
FOUND @ ADDR 30004000H, ID NUM= 87H
SCAN_FOR_OPT_CARD ENDS.
INSTALL_SMART_OPTIONS BEGINS.
FOUND GPS CARD; QTY=1, ID#=8028-2H.
INSTALL_SMART_OPTIONS ENDS.
QUERYING FOR SYMMETRICOM DEVICE. PLEASE WAIT...