4 upgrade installation of a primary domain con – Siemens Unix V4.0 User Manual
Page 71
Installing Advanced Server for UNIX
Installing server software (asxserver package)
Product Manual
U7613-J-Z815-6-76
©
S
iem
e
n
s
N
ix
dor
f
In
fo
rm
at
io
n
s
s
y
s
te
m
e
A
G
1
9
9
5
P
fad
: D:
\O
7
613
e6
\u
761
3e
.k
04
If the server is not started, the following message gives you information on how to upgrade
later:
Access Control Entries can be upgraded from the LAN Manager 2.x accounts
file (/var/opt/lanman/datafiles/accounts.lm2) after the user accounts and
groups have been replicated to this backup controller.
You will need to manually run lmxupgrade -A ... after this has occurred.
In this case, the administration files must be adjusted after Advanced Server for UNIX has
been started.
Ê
Start AS/X with
asx start.
Ê
Use the
net user
command to check whether the account data has already been trans-
ferred to this backup domain controller. If it has not been transferred, you can start the
transfer using the command
net accounts /sync
. If there are problems transferring the
account data, you may have to call
/var/opt/lanman/bin/joindomain
to re-establish the
connection again.
Ê
If the account data has been updated on this backup domain controller, the access
permissions must be created for Advanced Server for UNIX. Call
/var/opt/lanman/bin/lmxupgrade -YA.
Watch the output of the command for files and directories which are not found for
upgrading access permissions.
4.8.4
Upgrade installation of a primary domain controller from
Version 3.5 or 4.0
To upgrade a primary domain controller from a previous Advanced Server for UNIX version,
proceed as follows. In contrast to an upgrade installation from Version 2.x, the data can be
upgraded directly; no conversion has to be done.
Ê
Log on as system administrator
root
.
Ê
Start the installation procedure as described in the section
.
Ê
Select the
asxserver
package under AS/X.
Stop the server
Ê
Choose
y
to stop the server.