Siemens Unix V4.0 - Manual (Page 105)

Configuring Advanced Server for UNIX Configuring NetBIOS
Product Manual U7613-J-Z815-6-76
©
S
iem
e
n s N
ix
dor
f
In
fo
rm
at
io
n
s s y s te
m
e A
G
1
9 9 5
P
fad
: D:
\O
7 613
e6
\u
761
3e
.k
05
5.1.2.2 Commands used for configuring network interfaces
When configuring network interfaces, the following NetBIOS commands from
/var/opt/nbrfc/bin are used:
The cr_interfaces command creates the /var/opt/nbrfc/conf/interfaces.cfg configuration file
based on the information found in the UNIX system at runtime. The program runs at instal-
lation time but it can also be executed manually by the administrator e.g. to add a new
interface.
Syntax:
cr_interfaces [-F]
Options:
-F Force the creation of a new file. (Normally, an existing file is not overwritten.)
The get_config command reads the interfaces.cfg file; it does validity checks and displays er-
ror and/or warning messages as appropriate.
Syntax:
get_config
Use get_config before restarting NetBIOS whenever the interfaces.cfg file has changed in
order to detect inconsistent or faulty configurations.
Example output of get_config:
In order to check a new interfaces.cfg file you should compare the output of get_config with
the output of corresponding ifconfig(1M) commands.
The nbconfig command is used to view or to administer the state of the NetBIOS interfaces.
Following interfaces found
No.
0
1 Name
pnet0
madge0 IP Address
144.145.111.71
144.145.123.71 Broadcast
144.145.111.255
144.145.123.255 Netmask
0xffffff00
0xffffff00 Subnet
own
own Active
yes
no WINS
conf
no