Siemens pocket 2011 Tango - Manual (Page 68)

Code numbers and factory defaults
59
KAP17A.FM5 18.7.99 Gigaset 2011 Tango: A30852-X1106-B307-2-7619
Changing the handset PIN
Changing the PIN prevents unauthorized persons from,
for example, deleting entries from your telephone book.
( t means: browse using x , confirm using u )
Resetting the base station to factory defaults
You can use this procedure to reset the following settings
to factory defaults:
● Signaling method (DTMF/flash 100 ms) ➔ page 52
● Pause length following analog trunk/MSI ( 3 seconds)
➔
page 54
● Call allocation (collective call) ➔ page 49
The following stored data can be deleted:
● Analog trunk/MSI
( t means: browse using x
, confirm using u )
Z
OK
. t Settings t Handset Settings t Change PIN
Once "Change PIN" has been confirmed, you are request-
ed to enter the current PIN.
o Enter the current PIN (factory default "0000"). Enter the
new PIN and note carefully the number entered.
o Enter the new PIN again to confirm.
x Store the new PIN.
OK
The stored system code (➔ page 58) is not de-
leted.
All registered handsets remain registered.
Z
OK
.t Service
Call up menu item.
# 1 Start setting procedure.
o
Enter the four-digit system code (factory default "0000")
(➔ page 58).
u 2 %0 x
Reset the base station to the factory default.
REDIAL SET