Siemens pocket 2011 Tango - Manual (Page 57)

Operating more than one handset
48
KAP15.FM5 18.7.99 Gigaset 2011 Tango: A30852-X1106-B307-2-7619
Operating more than one handset
Registering/de-registering more than one handsets at the base station
You can operate up to six handsets from the Gigaset 2000
Tango family at a Gigaset 2011 Tango base station.
The handset supplied with your telephone is already reg-
istered at the base station with the internal call number
1 and base number 1.
Each additional handset that you purchase must be regis-
tered at the base station. We recommend that when you
are registering other handsets at the base station, to keep
the base number 1 for this base station.
Registering a Gigaset 2000C Tango handset at a base station
Prepare the base station
Register the handset
To avoid unauthorized users from registering a handset at
your base station, you must carry out the following proce-
dure within one minute.
( t means: browse usingx
, confirm using u )
You can only register handsets from the Gigaset
Tango family. It is not possible to register other
Gigaset handsets.
If you want to operate your handset at more
than one base station (up to six) (➔ page 52),
you must repeat the following procedure at
each base station.
? Press the base station paging key until you hear the logon
tone (after approximately ten seconds).
Z
OK
.t Settings t Register tBase 1
or
x u
If another base is available, at which the handset should
be registered.
o
x
Enter four-digit base code and confirm (factory default:
"0000"). The handset looks for the base available for reg-
istration.
The available internal numbers are shown on the display.
2 … 6 Enter the desired internal number for your handset.
The registration procedure is complete. The message "In-
ternal" appears on the display with the internal number.
Z OK
OK