Siemens pocket 2011 Tango User Manual
Page 22
External outgoing calls
13
KAP06.FM5
18.7.99
Gigaset 2011 Tango: A30852-X1100-B301-2-7619
Device control using dual-tone multifrequency signaling (DTMF)
If your telepone is connected to a line with dial pulsing
(DP), you can switch to dual-tone multifrequency signaling
(DTMF) once the connection has been set up.
Precondition: an external connection exists.
(
t means: browse usingx
,
confirm using u
)
Dialing a DSS number from a locked handset
If the handset has been locked for external calls (➔ page
39) and a DSS number is stored (➔ page 39), it is possible
to dial this direct number despite the lock.
Ending a call
Z
OK
.t Switch to Tone
Select and confirm.
When you have switched to DTMF, you can
switch between the two signaling methods dur-
ing the connection using the
R
signal key.
When the line is disconnected, the telephone
will automatically return to the original signaling
method.
Any digits or symbols that you enter after
switching signaling methods are not stored in
the memory for redialing.
o
Press any key on the handset. The direct number is di-
aled.
It is not possible to dial a DSS number from a
locked handset,
●
if "unrestricted trunk access or outward re-
stricted trunk access" is set (➔ page 38), or
●
if the base station is locked
(➔ page 33).
Replace the handset in the loading unit. The line is dis-
connected.
or
a Disconnect (on-hook key).