Siemens pocket 2011 Tango - Manual (Page 11)

Stepwise startup
2
Kap02.fm5 18.7.99 Gigaset 2011 Tango: A30852-X1106-B307-2-7619
Phone cord
Insert the RJ-11 plug on your phone cord into the base sta-
tion. The jack on the bottom of the base station is marked
with the symbol.
Insert the phone plug on your phone cord into your phone
socket.
Power cord
Insert the RJ-11 plug on your power cord into the base
station. The jack on the bottom of the base station is
marked with the symbol.
Insert the power cord plug-power supply into a 220/230V
socket (C39280-Z4-C59) or a 110/120V socket (C39280-
Z4-C69).
Step 4: Inserting the batteries into the handset
The handset is powered by two batteries.
Hold the handset with the keypad side facing down.
Slot the batteries into the battery compartment.
Slide the cover of the battery compartment from above
into the grooves in the handset and close the compart-
ment.
For safety reasons, the phone must only be op-
erated with the supplied Siemens
C39280-Z4-C59 adaptor for 220/230V voltage or
C39280-Z4-C69 adaptor for 110/120V.
Batt. compartment cover
Batt. comp. and batteries
Make sure that the +/– battery poles are aligned
correctly. The +/– marks on the plate must be
aligned with the +/– marks on the batteries.
The handset will not work if the batteries are in-
correctly inserted and it may be damaged.