Siemens pocket 2011 Tango - Manual (Page 12)

Stepwise startup
3
Kap02.fm5 Gigaset 2011 Tango: A30852-X1106-B307-2-7619 18.7.99
Step 5: Charging the batteries
To charge the batteries, place the handset in the handset
rest on the base station. The charging contacts on the bot-
tom of the handset must come into contact with the bot-
tom of the base station and its charging contacts. It does
not matter whether the keypad is facing up or down.
If you have correctly inserted the mobile unit for charging,
the LED under the battery symbol on the base station will
light up.
Step 6: Check signaling method
Telephone lines can use the following signaling methods:
● dial pulsing (DP)
● dual-tone multifrequency signaling (DTMF)
The factory default for your Gigaset 2011 Tango is DTMF.
Checking your own telephone’s signalling method
Setting the phone to dial pulsing (DP)
( t means: browse usingx
, confirm using u )
You can now make calls with your Gigaset 2011
Tango.
You must charge the batteries before you can
make any calls or settings. We recommend that
the batteries be charged for 16 hours without in-
terruption, e.g. overnight, for the initial startup.
For more information on the use of the batteries
(➔ page 62).
c
Press the off-hook key (corresponds to picking up the
handset on an ordinary phone). You will hear the dial tone.
o Press any digit, e.g. 2. If you can still hear the dial tone
you will have to set the signaling method to dial pulsing
(DP).
Z OK
.t Service Select the "Service" menu item.
#1 Start the setting procedure
o
Enter the four-digit base code (factory default:"0000")
(➔ page 7).
u @33 x Set dial pulsing (DP). REDIAL SET
The other signaling method settings are intend-
ed for the operation of the Gigaset 2011 Tango
in telephone systems (➔ page 52 ).