Siemens pocket 2011 Tango - Manual (Page 26)

Internal consultation calls and transferring calls
17
KAP08.FM5 18.7.99 Gigaset 2011 Tango: A30852-X1106-B307-2-7619
Transferring calls
When more than one handsets are in operation
It is possible to transfer an external call to an internal party
when more than one handset is in operation (➔ page 52).
(
When a telephone system is in operation
If a telephone system is in operation, you can transfer an
external call to another internal party. Please check the op-
erating instructions for the telephone system.
x Set up an internal connection.
[
o
Enter the number of the handset to which you want to
transfer the call (1 to 6). You will hear the internal ring
tone. The handset is being called. The external call is
held.
either
Wait until the internal party answers and inform him/her
about the external call you are about to transfer.
a Transfer the external call by pressing the on-hook key.
or
a Do not wait until the internal party answers and transfer
the external call directly by pressing the on-hook key.
Instead of pressing a , you can also replace
your handset in the charging unit.
If you have transferred the external call and the
internal party does not accept the call within 30
seconds, an automatic recall is carried out.
If you have transferred the external call and the
internal party is busy, an automatic recall is car-
ried out immediately.
If you accept the recall, you will be reconnected
to the external party. A recall is accepted in the
same way as all other calls (➔ page 8).
R Setup a consultation call. You will hear the dial tone. The
external call is held.
o Enter the desired extension number. The party in ques-
tion is called.
a Transfer the external call by pressing the on-hook key.