Siemens pocket 2011 Tango - Manual (Page 20)

External outgoing calls
11
KAP06.FM5 18.7.99 Gigaset 2011 Tango: A30852-X1100-B301-2-7619
Manually inserting a pause
If you repeatedly get the busy symbol following automatic
dialing from the telephone directory, e.g. after the country
code, you can enter a pause (three seconds), e.g. be-
tween the trunk or country code and the call number:
( t means: browse usingx
, confirm using u )
No answer or line busy
Redial
Repeating the last number dialed
You can call up a list with numbers for redial by pressing
the display key. You will be presented with a list of
the last five different numbers you called, including num-
bers which were dialed from the directory.
( t means: browse usingx
, confirm using u )
Z OK
u t Pause W
The dial pause "P" is shown on the display.
:
0043P123456
_
WEITER
▲ ▼
X
W
Replace the handset in the base station or charging unit.
The call is disconnected.
or
a Disconnect call ("on-hook").
You can use the redial function to repeat this
call.
z
x
Select the desired call number.
c Press the off-hook key. The number is dialled.
or
Z
Z OK
u t Dial number W
You can enter additional digits while the number
is being dialed.