Sharp UX-B800 - Manual (Page 36)

Batch Page Numbering
34
Use this feature to add a slash and the
total number of pages to each page
number on transmitted fax pages (for
example, "P. 1/5", "P.2/5", etc.). This
allows the recipient to check for missing
pages.
1 Load the document(s).
2 Press , then to show
[PAGE COUNTER].
3 Press .
Display: [ ENTER # (01 - 99) ]
4 Enter the total number of pages
(“01” to “99”) with the numeric keys.
Example: 5 pages .
5 If desired, press to set the
resolution and/or contrast.
6 Dial the receiving machine and
send the fax.
•
To cancel a batch number entry,
remove the document from the
feeder or press .
•
If the number of pages actually
transmitted is not the same as the
batch number entered, an alarm will
sound and [PAGE COUNT ERROR]
will appear in the display. “PAGE E.”
will also appear in the NOTE column
of the Transaction Report if printed.
FUNCTION
RESOLUTION/
RECEPTION MODE
STOP
Batch Page Numbering Sending a Fax From Memory
To increase transmission speed, you
can send a fax through the machine’s
memory. After transmission, the fax is
automatically cleared from memory.
Note: If a power failure occurs while
sending a fax from memory, you must
repeat the operation.
To send a fax through memory, load the
document, press , and dial using
one of the methods below. (Note that
an e-mail destination cannot be
selected.)
♦
Press a Rapid Key.
♦
Press , enter a 2-digit Speed
Dial number, and press .
♦
Enter the fax number with the number
keys and press .
♦
Press repeatedly to select an
auto-dial number and press .
♦
Press once to select the last
number dialled and press .
SPEED DIAL
If [MEMORY FULL] appears, see If
the memory becomes full on page 40.
all.book Page 34 Thursday, August 10, 2006 2:22 PM