Sharp UX-B800 - Manual (Page 11)

Loading Paper
9
1. Installation
Loading Paper
Approximately 200 sheets of A4-size
paper (60 - 80 g/m 2 ) can be loaded in
the paper tray (at room temperature;
maximum stack height should not be
higher than the line on the tray).
1 Fan the paper, and then tap the
edges against a flat surface to even
the stack.
2 Pull the paper plate forward and
insert the stack of paper into the
tray,
print side up.
Pull the received document
tray extension all the way out
Attach the
document exit tray
and flip out the
extension
Attach the paper tray
The stack must
not be higher
than this line
•
If paper remains in the tray, take it
out and combine it into a single stack
with the new paper.
•
Printing on the reverse side of the
paper may result in poor print quality.
•
Do not use paper that has already
been printed on or is curled.
•
Remove received faxes and other
printed output before about 50
sheets accumulate in the received
document tray (otherwise the sheets
may scatter).
If at any time the display shows [ ADD
PAPER &] / [PRESS START KEY ],
check the paper tray. If the tray is
empty, add paper. If there is paper in
the tray, take it out and then reinsert it.
When finished, press .
all.book Page 9 Thursday, August 10, 2006 2:22 PM