Sharp UX-B800 - Manual (Page 12)

Connecting the Power Cord
10
Plug the power cord into a 230 V,
50 Hz , earthed (3-prong) AC outlet.
♦
The power outlet must be installed
near the equipment and must be
easily accessible.
Caution! Remove all packing tape
before plugging in the power cord
(see page 8), or damage to the machine
may result.
The display will show [CHECK
CARTRIDGE] until you install the print
cartridge.
Connecting the Power Cord
♦
It is recommended that you install
surge protectors for the power and
telephone lines. Surge protectors can
be purchased at most telephone
specialty stores.
Print cartridge yield
SHARP UX-C80B replacement
cartridge
Ink Save mode OFF:
Approx. 480 A4 pages
Ink Save mode ON :
Approx. 800 A4 pages
(The initial cartridge has the same
yield as the replacement cartridge.)
♦
Ink Save mode is initially turned off.
To turn on Ink Save mode, see
pages 49 and 53.
Installing the Print Cartridge
Caution! Do not open the cover while
the machine is printing.
Note: Keep print cartridges sealed in
their packages until you are ready to
install them. It is recommended that you
do not use a cartridge that has been left
unused for a long time after opening, as
the print quality may be considerably
degraded.
♦
Make sure the machine’s power cord
is plugged in and paper is loaded in
the paper tray.
1 Open the cover (grasp the finger
grip).
all.book Page 10 Thursday, August 10, 2006 2:22 PM