Sharp UX-B800 - Manual (Page 16)

Setting the Reception Mode
14
Setting the Reception Mode
The machine has three modes for
receiving incoming faxes:
AUTO mode:
The machine automatically answers all
calls on two rings and begins fax
reception.
MANUAL mode:
All calls, including faxes, must be
answered by picking up the
machine's handset or an extension
phone connected to the same line.
TEL/FAX mode:
The machine automatically answers all
calls on four rings. If the machine
detects that a call is a voice call
(including a manually dialled fax), it
makes a special ringing sound to alert
you to answer. If the machine detects
that the call is an automatically dialled
fax, it begins reception automatically.
Volume Adjustment
Speaker volume
1 Press .
2 Press or to select
HIGH , MIDDLE , or LOW .
•
Press again to turn off the
speaker.
SPEAKER
SPEAKER
Ringer volume
1 Press or to select
HIGH , MIDDLE , LOW , or OFF .
(Make sure has not been
pressed, the handset is not lifted,
and a document is not loaded in the
feeder.)
•
The ringer will ring once at the
selected level.
2 If you selected “ OFF OK ? ” to turn
off the ringer, press .
SPEAKER
•
The currently set time appears
(example): [
TIME 12:19 ]
7 Enter a two-digit number for the
hour ("00" to "23") and a two-digit
number for the minute ("00" to "59").
Example: 9:25
8 Press . [ANTI JUNK #]
9 Press to exit.
STOP
To set the reception mode, make sure a
document
is not loaded in the
document feeder, and then press
until the desired mode
appears in the display.
For more information on receiving
faxes, see Chapter 4.
RESOLUTION/
RECEPTION MODE
all.book Page 14 Thursday, August 10, 2006 2:22 PM