Minolta Pi3505e - Manual (Page 81)

4 Configuring PCL Printer Driver Properties for Windows
4-14 Pi3505e Printer Driver
Output Setting Dialog Box
This dialog box appears when you click the Detail of Output Setting
button on the Setup tab. You can use it to configure stapling, hole
punching, and folding.
(1) Staple
This setting is available only when the Built-in Finisher (FN-117) is
installed on the machine. You can use it to staple the pages of one
printed document at a time.
• Off No page stapling
• Auto 2-points Pages are stapled at two points along the top
edge when landscape orientation is selected, or
along the left edge when portrait orientation is
selected.
• Top 2 points Pages are stapled at two points along the top
edge.
• Left 2 points Pages are stapled at two points along the left
edge.
• Corner Pages are stapled in upper left corner.
If you have the Saddle Kit (SK-1) equipped on the Built-in Finisher
(FN-117) , you can also configure the following settings in addition
to those described above.
• Center Pages are stapled in the center.
• Crease You can select Crease for the (3) Fold setting.
(1)
(2)
(3)