Multi-Tech Systems MT5600ZDX - Manual (Page 81)

81
Owner’s Manual
d. The user should not issue any sequence of commands to the modem which would
cause the modem to exceed the maximum allowable pause of 8 seconds from the
time the modem goes off hook until dialing begins.
e. For correct operation of the call progress monitor, the power has to be properly
connected and switched on.
Compliance with BS6328 Part 1
a. The modem is not suitable for use on circuits with British Telecommunications
signaling at a normal frequency of 2280 Hz.
b. The modem does not require signaling or otherwise employ the frequency range
dc to 200 Hz.
c. The modem may be connected to a point to point two-wire or four-wire Private
Circuit.
d. The modem does not require dc from the Private Circuit for correct operation. The
modem may be damaged if connected, in a private circuit mode, to a circuit
supplying dc current (the maximum permissible direct current is zero amps).
Modem CE Mark EMC and Safety Compliance
The CE mark is affixed to the enclosed Multi-Tech product to confirm
compliance with the following European Community Directives:
Council Directive 89/336/EEC of 3 May 1989 on the approximation of
the laws of Member States relating to electromagnetic compatibility;
and
Council Directive 73/23/EEC of 19 February 1973 on the
harmonization of the laws of Member States relating to electrical
equipment designed for use within certain voltage limits;
and
Council Directive 98/13/EC of 12 March 1998 on the approximation of
the laws of the Member States concerning telecommunications
terminal and satellite earth station equipment.