Multi-Tech Systems MT5600ZDX - Manual (Page 38)

38
Model MT5600ZDX
\K0 Clear data buffers and send break to the remote
modem.
\K1 Same as \K0.
\K2 Send break to remote modem immediately.
\K3 Same as \K2.
\K4 Send break to remote modem in sequence with
transmitted data.
\K5 Same as \K4.
*The third case is where a break is received from a remote modem during
a non-error corrected connection:
\K0 Clear data buffers and send break to the DTE.
\K1 Same as \K0.
\K2 Send break to DTE immediately.
\K3 Same as \K2.
\K4 Send break to DTE in sequence with transmitted
data.
\K5 Same as \K4.
Command: \Nn Error Correction Mode Selection
Values: n = 0–5
Default: 3
Description: \N0 Non-error correction mode with data buffering (same
as &Q6).
\N1 Direct mode.
\N2 V.42/MNP reliable mode.
\N3 Same as \N2.
\N4 V.42 reliable mode.
\N5 MNP reliable mode.
Command: \Vn Single Line Connect Message
Values: n = 0 or 1
Default: n/a
Description: \V0 Disables Single Line Connect Message.
\V1 Enables Single Line Connect Message, where the
format is: CONNECT, DTE speed>,Modulation>
Protocol>.
*Connect messages are contingent on X, W, and S95 command settings.