Multi-Tech Systems MT5600ZDX - Manual (Page 17)

17
Owner’s Manual
Figure 2-5. MultiModemZDX Initialization Setup
Other software programs require you enter an initialization string in the
software modem setup screen. If this is the requirement in your software
application, enter the following command string to initialize your modem:
AT&F. This setting configures your modem to operate optimally with
the software it is utilizing.
Hardware/Software Confirmation
To confirm that your modem (hardware) and communications package
(software) is working properly:
1. Go into terminal mode in your communications package.
2. To determine if your computer and modem are communicating properly,
Enter: AT At this point your video monitor should display OK. If
the characters you typed do not appear or if double characters appear, see
the troubleshooting section of this chapter.
3. To confirm how your MultiModemZDX is configured, enter AT&V.
The current MultiModemZDX configuration is displayed as show below.
Example:
AT&V
ACTIVE PROFILE:
B0 E1 L1 M1 N1 QO T V1 W0 X4 Y0 &C0 &D0 &G2 &J0 &K3 &Q5 &R1 &S0 &T4 &X0
&Y0
S00:002 S01:000 S02:043 S03:013 S04:010 S05:008 S06:002 S07:030 S08:002
S09:006
S10:014 S11:255 S12:050 S18:000 S25:005 S26:001 S36:007 S37:000 S38:020
S46:138
S48:007 S95:000