Multi-Tech Systems MT5600ZDX - Manual (Page 52)

52
Model MT5600ZDX
Bits 0-4 Desired line connection speed. If an invalid number is entered, the
number is accepted into the register, but S37 will act as if the default value
has been entered.
0 = Attempt automode connection. If N0 is active, connection is attempted
at the most recently sensed DTE speed (+MS command settings are updated
to the most appropriate values). If N1 is active, connection is attempted
at the highest possible speed (+MS settings are updated to 11,1,300,2880
to reflect V.34, automode, 300 bps minimum speed, and 28800 bps
maximum speed)--Default.
S38 decimal 0–255 20 This register specifies the delay
between the modem’s receipt of
the H command to disconnect (or
ON-to-OFF transition of DTR if
the modem is programmed to
follow the signal), and the dis-
connect operation. Applicable to
error-correction connection only.
If S38 is set to a value between 0
and 254, the waits for the remote
modem to acknowledge all data
in the modem buffer before dis-
connecting. If S38 is set to 255,
the modem does not time-out
and continues to attempt to de-
liver data in the buffer until the
connection is lost or the data is
delivered.
S39 Flow Control Bit-Mapped Options Status (Indicates the status
of command Options.) Default: 3
Bit 0-2 Status of Command Options
0 = No Flow Control
3= RTS/CTS (&K3)--Default
4 = XON/OFF (&K4)
5 = Transparent XON (&K5)
6 = Both Methods (&K6)
Bit 3-7 Reserved