Multi-Tech Systems MT5600ZDX - Manual (Page 30)

30
Model MT5600ZDX
Command: Wn Connect Message Control
Values: n = 0, 1 or 2
Default: 0
Description: W 0 Upon connection, the modem reports DTE speed
only (e.g., CONNECT 56000). Other responses are
disabled.
W 1 Upon connection, the modem reports the line speed,
the error correction protocol, and the DTE speed.
Other responses are disabled.
W 3 Upon connection, the modem reports DCE speed
only (e.g., CONNECT 28800). Other responses are
disabled.
*The Wn command controls the format of CONNECT messages. The
parameter value, if valid, is written to S31 bits 2 and 3. The Wn command
can be overridden by register S95.
Command: Xn Result Code Selection
Values: n = 0–4
Default: 4
Description: X0 Sends OK, CONNECT, RING, NO CARRIER, ERROR
and NO ANSWER); does not look for dial tone or busy
signal.
X1 Sends X0 messages and CONNECT speed.
X2 Sends X1 messages with NO DIALTONE.
X3 Sends X1 messages with BUSY.
X4 Sends all responses.
* If the modem is in facsimile mode (e.g., +FCLASS=1), the only message
sent to indicate a connection is CONNECT without a speed indication.
Command: Yn Long Space Disconnect
Values: n = 0
Default: 0
Description: Y0 Disable sending or responding to long space break
signal on disconnect.
Y1 Enables long space disconnect. In non-error correc-
tion mode, the modem will send a long space of four
seconds prior to going on-hook. In non-error
correction mode, the modem will respond to the
receipt of a long space (i.e., a break signal greater
than 1.6 seconds) by going on-hook.