Multi-Tech Systems MT5600ZDX - Manual (Page 75)

75
Owner’s Manual
Appendix B - Regulatory Information
FCC Regulations for Telephone Line
Interconnection
1. This equipment complies with Part 68 of the Federal Communications
Commission (FCC) rules. On the outside surface of this equipment is a
label that contains, among other information, the FCC registration
number and ringer equivalence number (REN). If requested, this
information must be provided to the telephone company.
2. As indicated below, the suitable jack (Universal Service Order Code
connecting arrangement) for this equipment is shown. If applicable, the
facility interface codes (FIC) and service order codes (SOC) are shown.
An FCC-compliant telephone cord and modular plug is provided with this
equipment. This equipment is designed to be connected to the telephone
network or premises wiring using a compatible modular jack which is Part
68 compliant. See installation instructions for details.
3. The ringer equivalence number (REN) is used to determine the quantity
of devices which may be connected to the telephone line. Excessive REN’s
on the telephone line may result in the devices not ringing in response
to an incoming call. In most, but not all areas, the sum of the REN’s should
not exceed five (5.0). To be certain of the number of devices that may
be connected to the line, as determined by the total REN’s, contact the
telephone company to determine the maximum REN for the calling area.
4. If this equipment causes harm to the telephone network, the telephone
company will notify you in advance that temporary discontinuance of