Multi-Tech Systems MT5600ZDX - Manual (Page 12)

12
Model MT5600ZDX
5. Turn on power by flipping the "ON/OFF" switch on the side of the
MultiModemZDX to the "ON" position.
6. Make sure modem and computer/terminal serial port baud rates are
adjusted. (Note that several programs can check this for you. If you have
MS-DOS 5.0 or higher, a program called MSD.EXE [Microsoft Diagnostics]
is in your DOS directory. Typing MSD at the DOS prompt brings up a
screen that provides a variety of information about your computer. Select
COM ports and it lists information about your com port, e.g., UART Type,
Address, and IRQ, to name a few. Once you know your serial port's UART
type, you can set your communications's software appropriately.)
7. Proceed to Chapter 3 of this manual, or to your data communications
software manual.
✳ #
Figure 2-2a. MultiModemZDX Connections
LED Indicators
The MultiModemZDX has ten LED indicators to report MultiModemZDX
status (such as verifying proper installation) and line activity (such as
monitoring the status of a connection).