Motorola 3460 - Manual (Page 62)

3460 Fast’R
3-10
Non-Option Set Parameters
This section describes parameters that are independent of the option set
selected. Determine whether the default options are correct for your site,
and set parameters as needed.
Table 3-5. Site-Specific Parameters
Parameter Default Option Available Option
Test Options
Accept RDL AT&T4=On AT&T5=Off
Modulation Options
Guard Tone Country-specific AT&G0=Off
AT&G1=550
AT&G2=1800
EC/DC Options
Buffers AT * NB0=Regular AT * NB1=Reduced
Automatic Call Unit (ACU) Options
Call Progress ATX0=Modem uses only NO
CARRIER and CONNECT
result codes.
ATX1=Modem uses only NO
CARRIER, CONNECT, and
CONNECT result
codes.
ATX2=Modem waits for dial
tone and uses only NO
CARRIER, CONNECT,
CONNECT and NO
DIALTONE result codes.
ATX3=Modem detects busy
signal and uses only NO
CARRIER, CONNECT,
CONNECT , and
BUSY result codes.