Motorola 3460 - Manual (Page 56)

3460 Fast’R
3-4
Managing Option Sets
The modem is pre-set with Option Set 1 as the active configuration.
• For asynchronous application protocols, build on Option Set 1
with any custom or site-specific parameter options
• For synchronous and leased-line application protocols, build on
Option Set 2 with any custom or site-specific parameter options
Select one of the following procedures to customize an option set. The
AT commands you need are listed in Table 3-1 and Table 3-2.
Selecting and Customizing Option Set 1
Manage an asynchronous modem configuration as follows.
Configuring a Modem for Async Operation
Step Stage
1. Issue the ATZ1 command
1
to load Option Set 1.
2. Optionally, set custom parameter options.
3. If you set any options in Step 2, issue the AT&W1 command to save
the configuration as Option Set 1. (Refer to Table 3-1.)
4. Issue the AT&Y1 command to make the modem use Option Set 1 at
subsequent power-ups. Option Set 1 is active.
1 You can set options and issue commands in either of these ways:
• By issuing AT commands through a communications application
• With Fast’RVu (see Chapter 4 )
Fast’RVu is especially useful for copying configurations to multiple modems.