Motorola 3460 - Manual (Page 32)

3460 Fast’R
1-18
Figure 1-8. Cabling an AccessWay Enclosure
Cabling One or More Enclosures to a Computer
You can connect up to four enclosures together and use Fast’RVu to
manage all the modems.
Cabling Enclosures Together for Fast’RVu
Step Action
1. Ensure that enclosures are securely installed in equipment racks.
2. Assign addresses to enclosures by setting the DIP switch on each
enclosure rear panel. Refer to Table 1-3.
3. Cable the enclosures’ NM OUT (or NC OUT) and NM IN
(NC IN) connectors together (Figure 1-9).
4. Cable a computer’s serial communications (COM) port to the
first enclosure’s NM IN connector.
5. Refer to Chapter 4 for instructions on using Fast’RVu.
Rear View, AccessWay Enclosure (Shown With Dual-Modem Cards, Individual
RJ-11 Connectors, and AC Power)
Modem Required in This
Slot for Management by
NMS or Fast’RVu
Power Cord
Upper (A) Telephone
Connectors, Slots 1-16
Lower (B) Telephone
Connectors, Slots 1-16
Computer
Connectors
IN OUT