Motorola 3460 - Manual (Page 109)

3460 Fast’R
A-11
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Note: shielded network-management and DTE cables are required for
compliance.
3460 AccessWay: This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to Part 15, Subpart
B, of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in
accordance with the instruction manual, may cause harmful interference
to radio communications. Operation of this equipment in a residential
environment is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Notes:
• Shielded network-management and DTE cables are required in all
configurations for compliance
• Ferrite beads or sleeves are required for compliance:
— Around 50-pin Telco cables, in a straight-through
configuration
— Around network-management cables, in a full-turn
configuration