Motorola 3460 - Manual (Page 129)

3460 Fast’R
B-19
1 =High. The modem sets RTS high. Use this option if the
computer does not provide RTS.
* RT Auto Retrain
When enabled, the modem retrains if the specified bit
error rate (BER) is exceeded.
0 =Off. The modem does not automatically initiate
retrains, but responds to retrains from a remote modem.
1 =Low BER. The Low BER setting is more sensitive than
the High BER setting.
2 =High BER. The High BER setting is less sensitive than
the Low BER setting. Note: Motorola recommends this
setting for most applications.
* SD Modem Speed Bar Display
0 =Display modem Receive Rate
1 =Display modem Transmit Rate
* SM Data Transfer Mode
Sets the async-application data transfer mode.
0 =Direct. The modem connects to the computer directly.
It does not use error correction. EC/DC OPT’s menu
options are disabled. In data mode, the computer rate
must match the modem rate.
1 =Normal. The modem provides rate-translation only; no
error correction or data compression. The break type is
standard. In data mode, the modem uses speed
conversion (if enabled). This lets the modem
automatically accommodate computers of different
rates.
AT Command Set (continued)
Command Option Description
The characters AT or at precede all commands except: +++, #####, and A/
Parameters and options shown shaded gray vary by country. For your country’s options,
refer to the 3460 Fast’R Reference Guide (T0022).
Default (pre-set) options are underlined.