Motorola 3460 User Manual

Page 36

3460 Fast’R

1-22

If your AccessWay has:

• Individual telephone cable connectors, connect cables from

the telephone service outlets to each modem connector.
The upper connector serves:

— Two- and four-wire leased line modems, on

four-wire leased line cards

— Modem A, on dual-modem cards

The lower connector serves:

— Dial-line connections, on four-wire leased line cards
— Modem B, on dual-modem cards.

• Mass-termination connectors, you should have two multi-line

cables from the telephone service outlets to the two mass-
termination connectors on the AccessWay rear panel, already
connected.

• Note: Mass-termination is not compatible with the two- or

four-wire leased-line/dial-line modem card.
The upper connector serves Modem A on dual-modem cards.
The lower connector serves Modem B on dual-modem cards.

Refer to the 3460 Fast’R Reference Guide for cable pin-outs.

A modem begins a self-test sequence when power is applied. A
modem indicates test results as follows:

• Successful completion: MR LED steady on.
• A problem by setting LEDs in one of these ways:

— MR: slowly blinking. TR: on. OH: off. CD: off.
— MR: off. TR: on. OH: on. CD: on.

You can also check self-test completion with Fast’RVu. Select
Status, then select:

• EIA to display DCD, DTR, DSR, CTS, and RTS signal states
• Device to display rate and mode parameters that describe the

modem’s current state

Note the LED pattern. Report any problem to Motorola Support.

Connect a cable from a computer serial port to the appropriate
Modem DTE connector on the enclosure rear panel.

To configure modems for operation, go on to Chapter 2.

Installing a Modem Card in an AccessWay

(continued)

Step

Action