Motorola 3460 - Manual (Page 58)

3460 Fast’R
3-6
Option-Set Parameter Default Options
This section lists the pre-configured option-set parameter options.
Table 3-1. Option-Set Default Options
Command
Pre-Configured Default Option
Option Set 1
(Asynchronous)
Option Set 2
(Synchronous)
Async Echo ATE1=On ATE1=On 1
Result Code ATQ0=Enable ATQ0=Enable
1
Result Form ATV1=Verbose ATV1=Verbose
1
Longspace Disconnect ATY1=On ATY0=Off
DCD Control AT&C0=High AT&C1=Normal
DTR Control AT&D2=Disconnect AT&D0=High
Line AT&L0=Dial AT&L1=2W Lease
AT Form AT&M0=Async AT&M1=Sync Data
1
CTS Control AT&R0=Async/Sync AT&R1=Normal
Remote Access AT&RA1=On AT&RA1=On
DSR Control AT&S0=High AT&S1=Normal
Clock AT&X0=Internal AT&X0=Internal
ACU Protocol AT * AC1= AT AT * AC0=None
Adaptive Rate AT * AP1=On AT * AP1=On
V.34 Asymmetric Rate AT * AR1=On AT * AR1=On
Answer Restoral AT * AS0=LL FAIL AT * AS0=LL FAIL
Break Handling AT * BK0=Destructive AT * BK0=Destructive 1
Mode AT * CA0=Orig AT * CA0=Orig
Direct Mode Async
Character Length AT * CL2=10 bits AT * CL2=10 bits
Connect Message AT * CM0=DTE Rate AT * CM0=DTE Rate
1
Default Dial AT * DA0=Off AT * DA0=Off
1
DTE (Terminal) Rate AT * DE23=Auto AT * DE23=Auto
Lease to Dial
Threshold AT * DI0=Low/Fast AT * DI0=Low/Fast
Parameters and options shown shaded gray vary by country. For details, refer
to Appendix B of the 3460 Fast’R Reference Guide.
1 Parameter option does not affect normal operation.