Motorola 3460 - Manual (Page 49)

3460 Fast’R
2-3
Leased-Line Synchronous Operation
Set up a modem for leased line operation with a synchronous protocol as
follows. Using a special remote control program to operate a host
computer or access a host network usually requires a synchronous
protocol. Communications-program commands vary, so use this
procedure only as a guide.
Basic Setup for Sync Leased-Line Operation
Step Stage
1.
Run your communications program. Assign the modem to one of
the computer’s serial communications (COM) ports.
2.
The modem is pre-set to Option Set 1. To set it to Option Set 2, run
your communications program, and issue the ATZ2 command.
3.
For information on setting custom configuration options, refer to
Chapter 3, Advanced Modem Setup.