beautypg.com

Australian and new zealand modem warning notice – Multi-Tech Systems MT5634ZPX User Manual

Page 82

background image

MT5634ZPX

82

Owner’s Manual

Australian and New Zealand Modem
Warning Notice

Australian Modem Warning Notice

Modems connected to the Australian telecommunications
network must have a valid AUSTEL permit. This modem has
been specifically configured to ensure compliance with AUSTEL
Standards. The following commands can affect compliance and
must not be set outside the acceptable range.

Modem Commands:

Command

Default

Permissible Range

A:

-

Do not use

ATB

B0

Do not change

AT&G

&G2

Do not change

AT&P

&P1

Do not change

ATSn

see table below

S-Register

Default

Permissible Range

S6

4

2 - 5

Call Attempts/Retries:

Applications software shall be configured so that no more than 3
attempts are made to establish a connection to a given number
(Note: if the modem can detect service tones, up to 10 attempts
can be made). There must be at least 2 seconds between call
attempts. If the call sequence is unsuccessful, there shall be a
delay of at least 30 minutes before attempting to call the number
again.

Failure to set the modem, and any communications software
used with the modem, to the values shown above will result in
the modem being operated in a non-compliant manner.
Consequently, there would be no permit in force for this
equipment, and the Telecommunications Act 1991 prescribes a
penalty of $12,000 for the connection of non-permitted
equipment.

re to set the modem, and any communications