Multi-Tech Systems MT5634ZPX - Manual (Page 42)

MT5634ZPX 42
Owner’s Manual
Command: &Y n Select Stored Configuration for Hard Reset
Values: n = 0
Default: 0
Description: &Y0 Select stored configuration 0 on power-up. (For
backward compatibility with some software.)
&Y1 Not supported—responds ERROR.
Command: &Z n=x Store Telephone Number
Values: n = 0, 1, 2, or 3
x = Dialing string
Default: None
Description: Stores telephone dial string x in memory location n.
Dial the stored number using the command ATDS=n.
Command: \G n Modem Port Flow Control
Values: n = 0
Default: 0
Description: \G0 Returns an OK for backward compatibility with some
software.
\G1 Not supported—responds ERROR.
Command: \J n Data Buffer Control
Values: n = 0
Default: 0
Description: \J0 Enable data buffer—serial port speed is independent
of connect speed.
\J1 Not supported—responds ERROR.
Command: \K n Set Break Control
Values: n = 5
Default: 5
Description: \K5 Modem sends break signal received from the DTE to
the remote modem.