Multi-Tech Systems MT5634ZPX User Manual
Page 36
MT5634ZPX
36
Owner’s Manual
W Wait for a new dial tone before continuing to dial.
(X2, X4, X5, X6, or X7 must be selected.)
S Dial a telephone number previously stored using
the &Zn=x command (see &Zn=x command for
further information). The range of n is 0-3.
,
Pause during dialing for time set in register S8.
;
Return to command mode after dialing. (Place at
end of dial string.)
!
Hook flash. Causes the modem to go on-hook for
one-half second, then off-hook again.
@ Wait for quiet answer. Causes modem to wait for a
ringback, then 5 seconds of silence, before
processing next part of command. If silence is not
detected, the modem returns a NO ANSWER code.
$ AT&T's "call card" tones detection.
^ Disable data calling tone transmission.
Command:
DS=
n Dial Stored Telephone Number
Values:
n = 0–3
Default:
none
Description:
Dial a number previously stored in directory number
n
by the
&Zn=x command .
Example: ATDS=3
Command:
E
n
Echo Command Mode Characters
Values:
n = 0 or 1
Default:
1
Description:
E0
Do not echo keyboard input to the terminal.
E1
Do echo keyboard input to the terminal.
Command:
F
n
Echo Online Data Characters
Values:
n = 1
Default:
1
Description:
F0
Enable online data character echo. (Not supported.)
F1
Disable online data character echo (included for
backward compatibility with some software).
Command:
H
n
Hook Control
Values:
n = 0 or 1
Default:
0
Description:
H0
Go on-hook to hang up.
H1
Go off-hook to make the phone line busy.