Multi-Tech Systems MT5634ZPX - Manual (Page 79)

MT5634ZPX 79
Appendices
i. internal software that has not been formally accepted by
BABT.
ii. external control software or external control apparatus which
cause the operation of the modem associated call setup
equipment to contravene the requirements of the standard
set out in BABT/SITS/82/005S/D.
All other apparatus connected to this modem and thereby
connected directly or indirectly to the British Telecom public
switched telephone network must be approved apparatus as
defined in Section 22 of the British Telecommunications Act
1984.
The REN number for this apparatus is 1.
Compliance with BS6789: Section 3.1 and
Part 2
a. The modem is not capable of allowing Auto Call using '999'
or other PABX emergency numbers.
b. Modes other than modes 1, 2, or 3 should not be used on
the BT PSTN. This modem is a mode 1 device.
c. Users are advised to check the numbers entered during the
Auto Call set up phase prior to dialing.
d. The user should not issue any sequence of commands to
the modem which would cause the modem to exceed the
maximum allowable pause of 8 seconds from the time the
modem goes off hook until dialing begins.
e. For correct operation of the call progress monitor, the power
has to be properly connected and switched on.