Upload, Uptime – Multi-Tech Systems MR9600 User Manual

Page 69

5 Commands

CommPlete Communications Server

[11] A:\MMM # update
Percent Done = 03%
2B

Updating

[12] A:\ # abort 2b
Are you sure you wish to abort the update? (y/n) y
Aborting . . .

upload

Parameter:

Pathname

Description:

Uploads from a computer connected to the MR9600 controller’s serial port connector the file

specified by pathname. Before uploading, binary files must be converted to ASCII data on the source
computer using a utility supplied by Multi-Tech. The format for the data is one or more lines of
hexadecimal data up to 80 characters in length, where each hexadecimal value is bracketed by square
brackets (e.g., [2b][3c]...[1c]). When the file has been uploaded, press E

or C

TRL

+D to complete the

upload.

Note

: For debugging use only under the direction of Technical Support personnel. Files will normally be

transferred using FTP.

Security:

Supervisor

Limitations:

Only ASCII files can be uploaded. This command does not support flow control, so the files

should be uploaded using an ASCII file transfer protocol with a 1 millisecond delay between lines.

Example:

[0] A:\MMM # upload mr9600.db

...data uploaded here...

2192 byte(s) written to ‘mr9600.db’

[1] A:\MMM #

uptime

Parameter:

Device or None

Description:

If no arguments are given, this displays the date and time since the last boot. If arguments

are given, then the time that the device(s) has been up is given in days, hours, minutes and seconds.

Security:

Operator

Example:

[05] A:\ # uptime
System up since – 1/8/2000 2:57pm - 0 Days 2 Hours 7 Minutes 5 Seconds

[06] A:\ # uptime 5a:6p
System up since - 1/8/2000 3:45pm - 0 Days 2 Hours 7 Minutes 12 Seconds

RAS

up for 000-00:55:03

Modem up for 000-00:55:03

Modem up for 000-00:55:02