Multi-Tech Systems MR9600 - Manual (Page 61)

5 Commands
CommPlete Communications Server 53
Description: This resumes all backplane and SNMP processing in the controller. It is done automatically
after the controller firmware is updated (haltsys is done automatically at the beginning of the update).
Security: Supervisor
Example:
[0] A:\MMM # resumesys
Resume processing
rm
See del.
rs
See reset.
se, setenviron
Parameter: None
Description: Allows you to check or change the environment values for the MR9600, to set the defaults
for use in the whole system, and to set up any component of the system.
Security: Supervisor
Example:
[0] A:\ # se
Getting System Defaults
MultiCommManager Environment Setup
1. System Defaults Setup (Required)
2. Device Specific Setup (Required)
Enter Selection (q(uit), <1>): 1
security
Parameter: None
Description: Prompts you to change the user ID and password for any security levels lower than your
own.
Security: Supervisor
Example:
[0] A:\MMM # security
Modify security information for which security level:
1. Guest level
2. Operator level
3. Supervisor level
Which one? 1
Enter User ID : guest
Enter new password : *****
Repeat new password : *****
Security information updated
[1] A:\MMM #