Gateway Server E-9520T - Manual (Page 78)

CHAPTER 6: Troubleshooting www.gateway.com
72
Interrupt Controller-2 error
BIOS POST could not initialize the Slave Interrupt Controller. This may indicate
a problem with system hardware.
CMOS messages
CMOS Date/Time Not Set
The CMOS Date and/or Time are invalid. This error can be resolved by
readjusting the system time in AMIBIOS Setup.
CMOS Battery Low
CMOS Battery is low. This message usually indicates that the CMOS battery
needs to be replaced. It could also appear when the user intentionally
discharges the CMOS battery.
CMOS Settings Wrong
CMOS settings are invalid. This error can be resolved by using AMIBIOS Setup.
CMOS Checksum Bad
CMOS contents failed the Checksum check. Indicates that the CMOS data has
been changed by a program other than the BIOS or that the CMOS is not
retaining its data due to malfunction. This error can typically be resolved by
using AMIBIOS Setup.
Miscellaneous messages
Keyboard Error
Keyboard is not present or the hardware is not responding when the keyboard
controller is initialized.
Keyboard/Interface Error
Keyboard Controller failure. This may indicate a problem with system hardware.
System Halted
The system has been halted. A reset or power cycle is required to reboot the
machine. This message appears after a fatal error has been detected.
Understanding sensors and sensor readings
Sensor type codes
The following section lists the sensors supported by the BMC, including type,
name, status, and current reading. The status and current reading information
is for example only.
Sensor type Sensor name Sensor status Current reading
Sys. ACPI Pwr State ACPI State Normal 5
Module/Board System Reset State Deasserted 0
Fan SYS FAN 1 Normal operating range 2362.39 RPM