beautypg.com

Replacing the system board – Gateway Server E-9520T User Manual

Page 62

background image

CHAPTER 4: Installing Components

www.gateway.com

56

Replacing the system board

To replace the system board:

1

Follow the instructions in

“Preventing static electricity discharge” on

page 28

. Make sure that you turn off the server, then unplug the power

cord(s) and all other cables connected to the server.

2

Follow the instructions in

“Opening the server case” on page 29

.

3

Set the server on its side to make it easier to work on.

4

Remove the PCI expansion cards by following the instructions in

“Installing

and removing PCI expansion cards” on page 41

.

5

Remove the memory modules by following the instructions in

“Installing

memory” on page 38

.

6

Remove the heat sinks and processors by following the instructions in

“Replacing or adding a processor” on page 46

.

7

Disconnect all cables from the system board, noting their locations and
orientation. (You will reconnect the cables after you install the new board.)

8

Loosen the two thumbscrews (2) that secure the system board to the
server.

2

1

1

1

1

1