Gateway Server E-9520T - Manual (Page 68)

CHAPTER 5: Using the BIOS Setup Utility www.gateway.com
62
3 Install a jumper across pins 1-2 of header J59-E.
Caution
Moving the jumper while the power is on
can damage your server. Always turn off
the server and unplug the power cords
and all other cables before changing the
jumper.
4 Follow the instructions in “Closing the server case” on page 30 .
5 Insert a diskette, CD or DVD, or a bootable USB “disk-on-key” containing
the AMIBOOT.ROM file.
6 Reconnect the power cords and turn on the server. The BIOS recovery is
initiated.
7 While the BIOS is being recovered, the monitor displays a blue screen and
the server will beep continually. The process is complete when the server
stops beeping.
8 Remove the diskette, the CD or DVD, or the bootable USB “disk-on-key.”
9 Turn off the server, then disconnect the power cords and all other cables
connected to the server.
10 Follow the instructions in “Opening the server case” on page 29 .
11 Remove the jumper from pins 1-2.
12 Follow the instructions in “Closing the server case” on page 30 .
13 Plug in the AC power cords and turn on the server, then verify that the
recovery was successful.