Gateway Server E-9520T - Manual (Page 48)

CHAPTER 4: Installing Components www.gateway.com
42
Caution
Do not touch the contacts on the bottom
part of the expansion card. Touching the
contacts can cause electrostatic damage
to the card.
4 Press down on the top of the expansion card latch (3) for the PCI expansion
card you are removing, then rotate the latch up (4) to release the card.
5 Gently remove the PCI card from the card slot, then lift the PCI card out
of the chassis.
Caution
Make sure that you only plug a PCI-X
expansion card into the PCI-X slot.
Plugging a PCI-X expansion card into a
PCI slot may damage the PCI-X card.
6 Position the new PCI expansion card over the PCI slot, then press the PCI
expansion card into the PCI slot.
7 From the back of the server, push the expansion card latch in to the locked
position.
8 If you opened the card guide initially, rotate the card guide tab down to
the locked position.
9 Follow the instructions in “Closing the server case” on page 30 .
10 See the card’s documentation for software installation instructions.