Replacing the hot-swap backplanes – Gateway Server E-9520T User Manual
Page 57
Replacing the hot-swap backplanes
www.gateway.com
51
Replacing the hot-swap backplanes
Caution
The hot-swap backplane is not
hot-swappable. Before removing or
replacing the backplane, you must first
turn off the server and all peripheral
devices attached to the server, and
remove the AC power cord(s) from the
power supply or wall outlet.
To replace the hot-swap backplanes:
1
Follow the instructions in
“Preventing static electricity discharge” on
. Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
2
Follow the instructions in
“Opening the server case” on page 29
.
3
Unlock the bezel (if necessary) and remove it by pulling it straight off the
front of the server.
4
Remove all of the hot-swap drive carriers from the server and make note
of which bay you remove each drive from. For instructions, see
and installing a hard drive” on page 33
.
5
Lay the chassis on its side to make it easier to work on.
6
Remove the system fans following the instructions in
7
Disconnect all cables from the backplanes.
8
Rotate the release latch (1) counter-clockwise, then pull the hard drive
cage (2) out of the chassis.
Caution
Pressing or pulling on any components
on the backplane could result in damage
to the backplane.
Caution
Make sure you do not pinch, bind, or
damage any cables as you install the
backplane.
9
Loosen the thumbscrew (3) holding the backplane on the back of the hard
drive cage, then slide the backplane (4) down to disengage the locking
tabs.