Grizzly G0696X - Manual (Page 27)

-24- g0605X1-6X1, g0696X-97X (mfg. 8/11+)
7. Fasten the support legs to the main extension
table with (8) m6-1 x 12 phillips head screws
and 6mm flat washers (see
Figure 33).
8. rotate both feet until they touch the ground,
and tighten the hex nuts against the legs to
secure the feet.
Figure 33. support leg fastened to main
extension table.
x8
9. Fasten the shelf end plate to the legs with (4)
m6-1 x 12 phillips head screws and 6mm flat
washers, as shown in
Figure 34.
Figure 34. installing shelf end plate on extension
table legs.
x4
10. place the shelf brackets between the cabinet
and support legs, and fasten with (4) m6-1 x
12 hex bolts, (4) 6mm flat washers and (2)
m6-1 hex nuts, as shown in
Figure 35.
Note: The flange on the shelf bracket must
point up to ensure proper installation.
11. place the lower shelf on the brackets.
Figure 35. shelf brackets installed.
shelf Bracket
Flange
x2
x2
G0605X1/G0606X1 Outfeed Table
1. turn the outfeed table upside down and
place it on a level surface.
2. install the feet, support legs, and shelf end
plate in the same manner as described in
Extension Table instructions on page 23.
3. place the extension table assembly upright
with the feet on the ground, align the slots in
the extension table bracket with the rear rail
mounting holes, then fasten the table to the
rail with (2) m8-1.25 x 16 flange bolts and
m8-1.25 hex nuts, as shown in
Figure 36.
Figure 36. outfeed table fastened to rear rail.
Bracket
x2
4. secure the lower shelf brackets to the sup-
port legs and cabinet with (4) m6-1 x 12 hex
bolts, (4) 6mm flat washers, and (2) m6-1 hex
nuts.
5. install the lower shelf on the brackets.