FUJITSU Server TX200 S6 - Manual (Page 93)

TX200 S6 Operating Manual 93
CSS components
Ê Remove the power cable from the installed power supply unit.
Ê Push the green catch in the direction of the arrow (1) while pulling the power
supply unit out of its mounting location (2) by the handle.
Ê Slide the new power supply unit into the empty slot until the locking
mechanism engages.
I
Make sure that the power supply unit engages correctly in the slot and
is locked in position.
This is the only way to prevent the power supply unit from sliding out
of its mountings and being damaged during transportation.
Ê Connect the newly installed power supply unit.
8.1.2 Hot-plug hard disk drives
The hard disk drives which can be ordered for the PRIMERGY TX200 S6 are
supplied already mounted in an installation frame so that defective hard disk
drives can be replaced and new hard disk drives can be added during operation.
The hard disk drive and installation frame together make up the HDD module.
V
CAUTION!
● The hard disk drive must not be removed from the installation frame
by anyone except a service technician.
● The HDD modules (drives) must all be marked clearly so that they
can be put back in their original places after an upgrade. If this is not
done, existing data can be lost.
● The hot-plug function is only possible in conjunction with a
corresponding RAID configuration.
Further information about the RAID configuration or RAID level can
be found in the RAID controller documentation.
● Do not touch the circuitry on boards or soldered parts. Hold the
metallic areas or the edges of the circuit boards.
● Before removing the unit, turn the power off and wait for about 30
seconds until the disk stops spinning completely.
● When the hard disk unit is starting up, you may hear a resonant noise
for a while, but this does not mean a failure.