FUJITSU Server TX200 S6 - Manual (Page 58)

58 Operating Manual TX200 S6
Hardware installation
I
Under certain circumstances, you will not be able to use some of the
parts from the rack installation kit supplied - you will need to use
original 3rd party rack parts instead.
Racks with installation depth of 735 mm
The lengths of the telescopic rails do not need to be adjusted with respect to
each other for the installation in rack systems with 735 mm installation depth.
Ê Secure the support systems as described in section "Installing the support
systems" on page 54 .
Ê Mount the server (see "Inserting the server" on page 56 ) and route the
cables as described in the original manual of the rack.
V
CAUTION!
Ensure that the safety lock has been inserted before the server is
inserted (see
figure 5 on page 54 ).
Racks with installation depth smaller/greater than 735 mm
The support systems can be used for installation depths of 714 - 785 mm. The
spring element of the support system is used to adjust the length as required.
Ê Secure the support systems as described in "Installing the support systems"
on page 54 .
Ê Mount the server (see "Inserting the server" on page 56 ) and route the
cables as described in the original manual of the rack.
V
CAUTION!
Ensure that the safety lock has been inserted before the server is
inserted (see
figure 5 on page 54 ).