Avid HD OMNI Preamp, I/O, and Monitoring Pro Tools HD Series Interface - Manual (Page 50)

HD OMNI Guide 46
Analog Output (OUTLVL)
In SETUP mode, the Analog Output Level
(OUTLVL) control lets you set the Output Gain
Level for each of the eight available analog
outputs.
To adjust between the Low Gain and High Gain
Analog Output Level:
1 Enter SETUP mode. The SETUP LED lights
green.
2 If necessary, turn the MONITOR encoder until
the display shows “OUTLVL” (OUTLVL is the de-
fault control when first entering SETUP mode).
3 Press the MONITOR encoder button to select
OUTLVL. The SETUP LED blinks on and off.
4 Turn MONITOR encoder until the display
shows “OUT 1.”
5 Press the MONITOR encoder button to select
OUT 1 (Analog Output channel 1).
6 Turn the MONITOR encoder to display either
“SPEAKR” (+10 dBu) or “LINE” (+24 dBu).
7 Press the MONITOR encoder button to select
the displayed Output. The display shows “OUT
1.”
8 Repeat preceding steps to set the Output Gain
Level for Analog Outputs 2–8.
9 Press SETUP button to exit OUTLVL and re-
turn to top level of SETUP Options menu. The
SETUP LED stops blinking and lights solid green.
10 Exit SETUP mode.
Analog Output Trim (OUTRIM)
In SETUP mode, the Analog Output Trim
(OUTRIM) control lets you set the Analog
Output Trim for each of the eight available
analog outputs from –40 dB to +10 dB in 0.1 dB
increments.
To adjust the Analog Output Trims:
1 Enter SETUP mode. The SETUP LED lights
green.
2 Turn the MONITOR encoder until the display
shows “OUTRIM.”
3 Press the MONITOR encoder button to select
OUTRIM. The SETUP LED blinks on and off.
4 Turn MONITOR encoder until the display
shows “OUT 1.”
5 Press the MONITOR encoder button to select
OUT 1 (Analog Output channel 1).
6 Turn the MONITOR encoder to adjust the An-
alog Output Trim (from –40.0 dB to +10.0 dB in
0.1 dB increments) for the selected Output.
7 Press the MONITOR encoder button to select
the displayed setting. The display shows “OUT
1.”
8 Repeat preceding steps to set the Analog Out-
put Trim for Analog Outputs 2–8.
9 Press SETUP button to exit OUTRIM and re-
turn to top level of SETUP Options menu. The
SETUP LED stops blinking and lights solid green.
10 Exit SETUP mode.
The Analog Output Gain Level control is
unavailable in SETUP mode when the
Hardware Setup dialog is open.
The Analog Output Trim control is unavail-
able in SETUP mode when the Hardware
Setup dialog is open.